Are you trying to receive HF signals? You need to set the V3 to run in direct sampling mode in order to receive HF. See instructions at www.rtl-sdr.com/V3.mlange wrote: ↑Mon Sep 10, 2018 8:46 pmThat could be the case - my bad timing
As to the current system, while it appears to work, all I'm receiving are local FM broadcasts. My antenna is an 88' dipole (it has a run with 46' of balanced ladder line, into a 1:1 balum, terminated into 50ohm coax that feeds into the RTL-SDR dongle.
Thoughts?
.
Help withRTL-SDR & SDR# No Device Selected error
-
- Site Admin
- Posts: 2431
- Joined: Mon Nov 19, 2012 11:54 pm
Re: Help withRTL-SDR & SDR# No Device Selected error
Re: Help withRTL-SDR & SDR# No Device Selected error
Things have been working quite well over here. The combination of the above yielded success - thank you to all.
There's quite a bit of powerful broadcasters in the region, so I'm going to source or build some filters for improvement.
Again, thanks for all the suggestions!
There's quite a bit of powerful broadcasters in the region, so I'm going to source or build some filters for improvement.
Again, thanks for all the suggestions!
Re: Help withRTL-SDR & SDR# No Device Selected error
Have just gone through a similar issue, 64bit windows 10, the 64bit driver simply doesn't work, I re-ran zadig after copying the 32bit driver into SDR Sharps directory and re-installed the driver, then it would show up in SDR Sharp 
