rtl-sdr.com

Hi All, new to this forum so be gentle with me please!!

I have successfully set up my dongle working with SDR# and all works OK. I have downloaded and installed DSDPlus following the great video by TechMinds. I'm pretty sure I have everything properly configured, but when I Tx on a DMR radio (simplex) the SDR# Spec An and Waterfall show it 100%, but it is simply not being seen by DSDPlus.

I've triple checked everything and I'm sure all of the Virtual audio settings are correct. Also pretty sure the windows sound settings are right.

Don't know where to go next really.....help please

DSD+ has an audio waveform monitor screen, does that show any movement, or is it flat?

Put up some screenshots of your setup if you can too.

I have the same problem, dsdplus has signals but not decodeing, DSD+ audio waveform monitor screen, does show movement, but the decoding windows have not any shows

I am having this exact same issue

Usuall SRD settings are to turn AGC off, set bandwith to 12.5khx , smaple rate to 1.92 or less and make sure audio filter is off