I was looking for a way to display e.g. DME, TACAN transponder pulse(pairs). Using SDR# a dash of an DME or TACAN ID, which is about 640 ms long, is only shown as a very thin line in the waterfall diagram. Is there a way to stretch the waterfall resolution to show single DME or ADSB pulses or a way to show the pulses in time domain like in the attached picture below, I have not found away?
To give you an idea what I am looking for look at the two pictures taken with a spectrum analyser. A TACAN PAM across all transmitted pulses is in the top picture and a RPG with PAM across it in the lower picture.
Main forum to discuss RTL-SDR related topics.
2 posts • Page 1 of 1
- TACAN-PAM&RPG.png (38.18 KiB) Viewed 657 times
I am not sure I understand your question, but in SDR# the "FFT Display" tab is where you adjust resolution and speeds of both the spectrum-display and the waterfall-display.