Page 1 of 1

Home-brew USB, VFO tuning knob.

Posted: Wed Mar 17, 2021 10:38 am
by sacentre
I just finished this USB tuning knob today so here are a few photos. All it consists of is the guts of a $5/- mouse using just the scroll wheel encoder and a few other bits I had knocking about. Luckily, I had the big black plastic knob left over from an old piece of photographic kit.

All that was necessary was to reposition the encoder to be parallel with the PCB instead of at 90 degrees to it and then modify the spindle of an old VR to drive the encoder. The original red optical encoder LED (LED1) has been replaced with a small green one on the top panel (just because I like flashing lights).
20210317_172905.jpg
20210317_172905.jpg (597.41 KiB) Viewed 1161 times
20210317_173037.jpg
20210317_173037.jpg (630.3 KiB) Viewed 1161 times
20210317_181707.jpg
20210317_181707.jpg (375.91 KiB) Viewed 1161 times
All it does is what the mouse scroll wheel would do so it will work with any software on any platform that can use a USB mouse.

Re: Home-brew USB, VFO tuning knob.

Posted: Fri Mar 19, 2021 12:53 am
by joe36
VERY nice! A+
Joe

Re: Home-brew USB, VFO tuning knob.

Posted: Fri Mar 19, 2021 4:50 am
by sacentre
Thanks, Joe.
So nice to have a VFO knob to turn and so easy to do. The only problem with it I realised afterwards was the rotational direction was wrong - clockwise = frequency down and vice versa. There's a tweak to the Windows registry that can reverse the direction of a mouse scroll wheel but this didn't work for me for some reason. In the end, it was easier just to turn the PCB over.
Trevor

Home-brew USB, VFO tuning knob MkII

Posted: Mon Apr 05, 2021 10:53 am
by sacentre
20210405_184419.jpg
20210405_184419.jpg (472.87 KiB) Viewed 652 times
20210405_184412.jpg
20210405_184412.jpg (485.27 KiB) Viewed 652 times
20210405_184355.jpg
20210405_184355.jpg (391.93 KiB) Viewed 652 times
I decided to do an upgraded version using the same mouse innards but retaining the optical mouse function and L/R buttons.