Page 1 of 1

RTL LNA

Posted: Sat Jun 15, 2019 10:38 pm
by Turbo68
I bought 3 of the Rtl Adsb Lna in the past few weeks tried them yesterday only 1 works other 2 dont work at all what can be done..

Regards Lino...

Re: RTL LNA

Posted: Sun Jun 16, 2019 4:34 am
by rtlsdrblog
I've only seen one failed ADS-B unit in the last 500 orders so far so it seems a bit unlikely for 2/3 to fail.

What exactly is not working? No signal, no light? Can you confirm if the light turns on (remove one screw to look inside). Is your antenna ESD protected if it's outside?

And just to confirm, you are using this LNA at 1090 MHz? (We had a few people who were confused and didn't understand that the ADS-B LNA was for ADS-B 1090 MHz only)

If you think those two are really faulty please email us at [email protected] and we'll be happy to arrange a replacement.

Re: RTL LNA

Posted: Sun Jun 16, 2019 12:09 pm
by Turbo68
Yes i am using them for 1090mhz only nothing working tried 3 different bias tee and they havent worked except one and its doing an excellent job..

Regards Lino..

Re: RTL LNA

Posted: Thu Oct 03, 2019 9:42 pm
by Username
I can recommend this Company: http://stores.ebay.com/gpiolabs/
I use there LNA I got maybe ~10 and the worked fine. :D

Re: RTL LNA

Posted: Wed Dec 11, 2019 3:16 am
by Bangka76
I too recently purchase a RTL-SDR Blog ADS-B LNA. I'm using RaspberryPi with FligthRadar24 software and RTL-SDR V3 dongle.

Before connecting the LNA I was getting reasonable performance from my set-up.
Before fitting LNA.png
Before fitting LNA.png (11.44 KiB) Viewed 222 times


After connecting the LNA my hits went basically down to zero.
After fitting LNA.png
After fitting LNA.png (9 KiB) Viewed 222 times
I understand I need to activate the bias tee, which I seem to be having trouble, but I was wondering if the bias tee is not on should I still be getting some hits or is it normal that there will be nothing at all until bias tee is on?

Re: RTL LNA

Posted: Wed Dec 11, 2019 2:23 pm
by Username
I recommend to buy a LNA form here: http://stores.ebay.com/gpiolabs/
The are perfect and can powered via USB Cable.

I got an Pi and the crap make A LOT OF NOISE in comparison to my Pc.

Re: RTL LNA

Posted: Fri Dec 13, 2019 6:12 am
by rtlsdrblog
Bangka76 wrote:
Wed Dec 11, 2019 3:16 am
I too recently purchase a RTL-SDR Blog ADS-B LNA. I'm using RaspberryPi with FligthRadar24 software and RTL-SDR V3 dongle.

Before connecting the LNA I was getting reasonable performance from my set-up.
Before fitting LNA.png

After connecting the LNA my hits went basically down to zero.
After fitting LNA.png

I understand I need to activate the bias tee, which I seem to be having trouble, but I was wondering if the bias tee is not on should I still be getting some hits or is it normal that there will be nothing at all until bias tee is on?
You definitely need the bias tee to get anything. If the LNA is unpowered, it will simply block signals.