Page 1 of 1

Bulk-In, Sharp says no device selected.

Posted: Tue Nov 17, 2020 9:55 pm
by PeterJanes
Works okay with normal SDR but comes up No device selected on new HF - UHF dongle using Bulk-In on Win 10 64b. Comes up on Zdiag as two instances. In device toolbox, greyed out with E4000 on top RH corner. Tried win7 64b with same result. The device is seen on "USBview." Spent hours today on this. I have now tried win7 64b and when Zadiag sets bulk interface it comes up on Sharp Config, rtl2832 OEM but still says device not selected. Also, I can plug my usb dongle device in any port and that works.