Just wanted to ask if someone has any ideas on what might be going on with the Raspberry Pi 3B+ software for the KerberosSDR? For some reason, I'm unable to get anything sensible out of the KerberosSDR util for Raspbian/Linux.
The problem is that although the kerberossdr util starts up without any major issues, the waveform/spectrum views in the KerberosSDR main program window are NOT updating at all. No matter what I try. I had the same problem with the latest pre-built RPi3B+ image that was provided on the Quick Start Guide page.
When I installed the software to my own RPi3B+ Raspbian environment, the end result was exactly the same. I had no problems installing the packages. Even a dry run with the "rtl_test -d<X>" worked out fine with all four of the KSDR's receivers - not a single error or a lost packet.
I followed all the required steps closely when I installed kerberossdr on to my own RPi 3B+ / Raspbian Stretch build, and for some reason that completely eludes me, nothing seems to work when it comes to redrawing the waveforms in any of the program tabs.
The "Power level" shows a green "OK".
The "Update rate" shows "-ms" (as in: it's not updating.)
Clicking on this, that or the other button doesn't do anything. The same issue was in the pre-built image, straight from the box.
These are the only lines I get in the Linux shell before the program starts:
Code: Select all
3 Starting KerberosSDR kill: (1449): No such process
All help would be kindly appreciated, once more.