Display Active Frequency ?

Need help installing or figuring out something about your SDR? Ask here.
Post Reply
Logit
Posts: 4
Joined: Fri Mar 23, 2018 8:53 pm

Display Active Frequency ?

Post by Logit » Thu Jul 12, 2018 10:22 pm

I am using a IF TAP PANADAPTER BOARD from KD2C. The board enables me to tap into the First IF of my Kenwood TS-450SAT.

The IF Freq. is 73.05.

When using v3 of the SDR Software ( https://www.sdr-radio.com/Software/Version3 ), the receive frequency has to coincide with the IF Frequency in order that the program works in my scenario.

https://www.amazon.com/clouddrive/share ... yGdK4imdk0
Freq 1.jpg
Freq 1.jpg (61.23 KiB) Viewed 202 times
Other users of v3 are able to display the active frequency (the frequency displayed on their transceiver) where the DB Indicator is located. In the picture where you see -104db.

Try as I might, I have been unable to display my active frequency.

Can anyone advise how this is done ?

rtlsdrblog
Site Admin
Posts: 1788
Joined: Mon Nov 19, 2012 11:54 pm

Re: Display Active Frequency ?

Post by rtlsdrblog » Fri Jul 13, 2018 12:29 am

Did you configure SDR-Console with your IF?

I believe that there is an "External Radio" option somewhere in SDR-Console where you can set the IF Output frequency.

Post Reply