Getting bias-t switch to work on Raspbian Buster

Need help installing or figuring out something about your SDR? Ask here.
Post Reply
K3RLD
Posts: 17
Joined: Sun Sep 01, 2019 12:43 am

Getting bias-t switch to work on Raspbian Buster

Post by K3RLD » Sat Sep 14, 2019 5:01 pm

Ok, somewhat related to my previous post about a Satnogs station, I am now trying to install the bias-t switch onto a raspberry pi running buster. When I run cmake .., I get the following:

Code: Select all

LibUSB 1.0 required to compile rtl-sdr
This never occured on stretch. Any advice?

K3RLD
Posts: 17
Joined: Sun Sep 01, 2019 12:43 am

Re: Getting bias-t switch to work on Raspbian Buster

Post by K3RLD » Sun Sep 15, 2019 2:09 pm

so the following solved the problem:

Code: Select all

sudo apt install libusb-1.0-0-dev
I suspected as much, but was concerned that doing so may "break" the satnogs setup..... it didn't. Works just fine, now.

Post Reply