inter-board jumpers

Need help installing or figuring out something about your SDR? Ask here.
Post Reply
ReadyKilowatt
Posts: 1
Joined: Sat Sep 21, 2019 7:47 pm

inter-board jumpers

Post by ReadyKilowatt » Sat Sep 21, 2019 7:53 pm

Trying to get board calibrated, but had problems with port 1. In the process of troubleshooting I determined the the coax jumper from the calibration network board to the SDR module was pinched between the case and broken. Any idea for a suitable replacement? Or can I purchase one? Not sure if it was from the factory this way or I goofed up.

rtlsdrblog
Site Admin
Posts: 2321
Joined: Mon Nov 19, 2012 11:54 pm

Re: inter-board jumpers

Post by rtlsdrblog » Sun Sep 22, 2019 10:19 am

Are you talking about KerberosSDR? Contact us as [email protected] and [email protected].

Post Reply