Yes you can use CLK_IN, and set the jumper to SLAVE. But it will only accept a 28.8 MHz input.VLBI_2020 wrote: ↑Tue Sep 08, 2020 7:58 pmCan the Kerberos 4 channel board accept a clock input signal? I'm exploring the possibility of using this board in a VLBI setup since my group has access to multiple hydrogen masers. Is the only way to sync the Kerberos receiver clocks with an outside source to have a separate clock breakout board take the 10MHz maser signal and solder four of its 28.8MHz outputs to the four receivers directly? Is there another way?
Discuss KerberosSDR - 4x Coherent RTL-SDR