Getting bias-t switch to work

Need help installing or figuring out something about your SDR? Ask here.
Post Reply
Posts: 2
Joined: Sun May 24, 2020 5:27 am

Getting bias-t switch to work

Post by msaleh » Thu May 28, 2020 9:34 pm

Ok, somewhat related to my previous post about a Satnogs station, I am now trying to install the bias-t switch onto a raspberry pi running buster. When I run cmake. I get the following:

Code: Select all

LibUSB 1.0 required to compile rtl-sdr
This never occured on stretch. Any advice?

Site Admin
Posts: 2743
Joined: Mon Nov 19, 2012 11:54 pm

Re: Getting bias-t switch to work

Post by rtlsdrblog » Fri May 29, 2020 5:48 am

sudo apt-get install libusb-1.0-0-dev should do it.

Post Reply