SDR# and DSDplus Decoding issues

Need help installing or figuring out something about your SDR? Ask here.
Post Reply
Posts: 1
Joined: Mon Jun 29, 2020 12:35 am

SDR# and DSDplus Decoding issues

Post by tonyhowie1991 » Mon Jun 29, 2020 12:51 am

Evening Guys,

This is my first post and I'm new into SDR so please excuse me being a total noob. I have a NooElec NESDR currently running on SDR# I have managed to set it up with DSDplus using VBAudio to route the audio from SDR# and it seems to be receiving the signal. i have setup the correct inputs and outputs and After having a play around with the Gain I managed to turn the "CACH ERR" lines on the decoder into something that looks a bit more promising. The problem I am facing is that DSDplus is not decoding to an audible signal. Now and again I will hear some clicks at the start of a transmission which makes me think that I have something set incorrectly. These clicks only appeared after I turned my volume gain down considerably but unfortunately I've not received any voice through as of yet. Please can someone point out what I am doing wrong? I have my bandwidth set to 8,000 / NFM, and have turned audio filtering off, I also have automatic gain control on. (I've tried this manually too) Please see the attached screenshot of my sdr settings. Thanks in advance!
Untitled.png (571.91 KiB) Viewed 401 times

Posts: 602
Joined: Sun Oct 09, 2016 7:27 am

Re: SDR# and DSDplus Decoding issues

Post by Username » Mon Jun 29, 2020 10:06 am

I have my bandwidth set to 8,000 / NFM
12500khz Bandwith and BS Data mean the Transmit what ever but not Audio.

Site Admin
Posts: 2699
Joined: Mon Nov 19, 2012 11:54 pm

Re: SDR# and DSDplus Decoding issues

Post by rtlsdrblog » Sat Jul 04, 2020 6:53 am

Appears to be a data only channel, try a different channel.

Post Reply