Osmo-FL2K: A TX-Only SDR Hacked From Commodity $5 USB to VGA Adapters – Demos Available for Transmitting WBFM, GSM, UMTS, GPS
Osmocom are some of the people behind the original discovery and development of the RTL-SDR (in particular Steve M), and today it looks like they have done it again by releasing exciting news of a way to turn a commodity $5 USB to VGA adapter into a TX-only capable SDR. They call their discovery 'osmo-fl2k', as the magic chip that makes it all happen is a Fresco Logic FL2000.
The discovery is based on the fact that the VGA specific HYSYC/VSYNC synchronizations on the FL2000 chip can be disabled, allowing for a continuous stream of samples to be sent to the VGA digital to analog converter (DAC). The FL2000 also implements a cheaper method of streaming data compared to other devices which allows these to be $5 devices.
The supported hardware appears to be any USB to VGA adapter that uses the FL2000 chip. They note that these are often advertised as "USB 3.0 to VGA" adapters with a maximum resolution of 1920 x 1080 for USB 3.0 and 800 x 600 for USB 2.0. Over on Amazon the cheapest one we've found (note not yet confirmed to be compatible) that meets the Osmocom description appears to be going for $7.49 and is fulfilled by Amazon. We've seen prices of $5.11 on Aliexpress and $5.99 on eBay too. There appears to be no difference between the brands of these units, as the 'brands' are just private labelled from the same factory, as anyone can add a brand to a generic product.
Once sellers catch on to the fact that these devices are going to be popular we expect them to most likely start raising prices.
In terms of TX performance and functionality, osmo-fl2k should be better than RPiTX as it uses an actual DAC, instead of just PWMing a pin. It appears that the device can transmit on a fundamental frequency anywhere from HF up to about 157 MHz, and then signal harmonics can be used to extend the range all the way up to around 1.7 GHz or maybe even higher. Having harmonics does mean that like other cheap TX methods, the signal is not clean and so proper filtering would be required before any sort of higher power transmission would be legal.
The highest fundamental frequency available also appears to be related to the performance of your PC's USB 3.0 controller. The worst USB 3.0 controller that they tested maxed out at 115 MS/s, whereas the best was 157 MS/s (theoretical max should be 160 MS/s). A USB 2.0 controller only gets a maximum sample rate of 14 MS/s.
So far the team have released software examples for transmitting DVB-T, GSM, UMTS (3G) and GPS, and have mentioned that they have also successfully transmitted LTE and DAB too. There is also an example for transmitting WBFM audio with RDS via the pacat Linux command and sox. The image below shows the FL2K-SDR working as a GSM base station.
If you're interested in more information, Osmocom have released the slides from a presentation that they made at a OsmoDevCon presentation on April 22. The video presentation is also expected to be released soon at media.ccc.de.
Looks like the hack uses just the Red output.
Seems to me, just on an off-the-top-of-my-head impression, that the three outputs should be synchronized well enough that you could use them to produce three separate outputs for a three-element mutiple-output beam steering or null-steering transmitter. (Perhaps with reduced bandwidth unless you have a lot of processor power.)
If you were frequency shifting, though you’d need both I and Q on at least one of the channels to get the phase relationships right, so with three outputs you’d be limited to two antennas.
With 12GB/s memory bandwidth and 8 cores(4xA15+4xA7), I don’t see that as being outside of the limits of an XU4 with well selected SIMD instructions and good fast DSP. It may not be trivial, but it should be possible. A XU4 has roughly 5x the number crunching power of a RPi3. It is a bit of a beast, but to run at that level of performance continuously a better cooling solution than the default they ship would be required.
Can you please explain a bit more.
I think you are saying that the computer CPU has to be powerful enough to create a large signal in order for the DAC to transmit a small signal.
They are available in Phillipines for $8 on Lazada. I think this will be a lot of fun. Pity its USB3 for best result. I look forward to some Orange Pi and Raspberry Pi playing.
I can see this causing the ODROID-XU4 to be more popular.
The host computer is supposed to upsample the baseband signal to150 MSPS for the DAC. This excludes a large number of CPUs/computers, including the Odroids.
Can you please explain more.
If you truly want to exploit the 150MS/s sampling rate of the dongle, you will going to need a lot of processing power. But if you don’t do, you may not be able to transmit on certain frequencies even if your signal is actually narrow-banded (because this thing does not come with a frequency mixer, you have to up-mix in software).
That said, it should still work on a Raspberry Pi or on a Odroid. It is just that the processing speed of the CPU will limit the use case of the dongle.
Much SDR, very frequency. How can I LTE?
U can LTE buy using gr8 open source software!!111!one!eleven
That’s cool! The rtl-sdr USB stick v4 will hopefully be a fully RX&TX capable low-lost SDR… 😉