Receiving Starlink Beacons with an RTL-SDR and LNB

Derek OK9SGC has recently posted a write-up of how they’ve been able to receive the Ku-band beacon signals from the Starlink constellation of communication satellites continually launched by SpaceX since 2015. While we recently covered Starlink Beacons being captured with a HackRF Supercluster Derek has noted that receiving the beacons requires little more than an LNB, a low-cost SDR such as the RTL-SDR V3 and a power injector to provide 12V DC to the LNB. Derek notes that a dish is not even required as the beacons transmit with high power.

Starlink Beacon Receiver Setup

Due to the low earth orbit and thus high speed of travel of the Starlink constellation you’ll notice strong Doppler effect drifts in your received signal. Derek notes that it may be interesting to perform Doppler analysis on the satellites with the satellite tracking toolkit for radio observations (strf) software. He also noted that in the 30 minutes he was receiving for, there was almost no point in time where a beacon was not being received, indicating that the Starlink constellation is close to achieving 100% sky coverage. 

Derek has made the process easy to understand and illustrates just how easy it is to listen to these beacon signals. Of course we note that these are just the beacons, and they carry no data. Still they are fun signal to receive, and doppler analysis could reveal interesting information about orbits. 

Starlink beacons shown in a fast FFT (LEFT), and slow FFT (RIGHT)

One comment

  1. A person

    cool article, and I really am nitpicking here but “communication satellites continually launched by SpaceX since 2015”

    The first Starlink test satellite launch was February 2018

Post a comment

You may use the following HTML:
<a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <s> <strike> <strong>