Tip to Reduce Radio Interference on the RTL-SDR

A few months back we posted about a tip to reduce RFI (Radio Frequency Interference) on the RTL-SDR. Now Akos from the SDR for mariners blog has tried this tip for himself and written about his experience with it, after getting inspired to by a post in the rtl-sdr.com/forum.

To reduce RFI, the tip recommends disconnecting the shield connection of the USB cable from the ground connection of the RTL-SDR dongle. This overcomes a design flaw in the RTL-SDR which allows the shield of the USB extension cable to act as an antenna, causing unwanted RFI.

What Akos did was to remove the metal part of the USB extension cables connector to prevent any ground connection. This already reduced an interfering signal by 10dB. He also found that wrapping the connection point in foil further reduced the noise. Connecting coax to the ground then coiling it up and putting the RTL-SDR in the center of the coil also appears to significantly reduce RFI.

Update: Akos has also tried using ferrite chokes on the USB cable, and also found they significantly reduce interference.

Check out the full post by Akos for more information here

RFI noise reduction in the RTL-SDR

Subscribe
Notify of
guest

9 Comments
Inline Feedbacks
View all comments