Hermes-Lite: A Low Cost Amateur Radio SDR Made from A Repurposed Cable Modem Chip
The HPSDR Hermes SDR is an open source amateur radio SDR transceiver project that was released as far back as 2011. More recently Steve Haynal has been working on a Hermes-Lite project which is intended to be an opensource open hardware low cost amateur radio HF transceiver which is based on the HPSDR Hermes SDR project software and FPGA DSP implementation.
The Hermes-Lite is able to be very low cost (less than $300) because it is based on the AD9866 chip which is a mass produced RF front end (LNA + ADC & DAC) used in cable modems. Because it is a mass produced commodity, the chip only costs approx. US$35-$25 on Mouser depending on quantity. The chip has a 12-bit 80 MHz ADC and DAC, meaning that if used without any analog mixer front end (like in the Hermes-Lite) it can receive the entire spectrum between 0.1 to 38 MHz all at once.
The Hermes-Lite is also a lot more than just the RF chip, as it contains a set of switched RF filters and a 5W power amplifier for TX. It also interfaces with a PC via Ethernet and has a built in FPGA for DSP processing.
Recently Steve presented at the FOSSi Foundation Latch-Up conference on May 4-5, and a YouTube recording of his presentation is shown below.
[First seen on The SWLing Post]
Lot of information about the HL2 here : https://wiki.electrolab.fr/Projets:Lab:2018:Hermes_Lite
There is a step by step on how to build the board by yourself.