ramses-sdr: Decoding Honeywell Evohome Heating System Traffic with an RTL-SDR

Thank you to Hans de Vries for writing in and sharing ramses-sdr, an open-source receiver for Honeywell Evohome's RAMSES II traffic at 868.3 MHz. Evohome is a wireless multi-zone heating control system, and RAMSES II is the protocol its radiator valves, thermostats, and boiler bridges use to talk to the controller. Hans built ramses-sdr to see when the radiator valves were calling for heat and what the OpenTherm bridge was reporting.

The demodulator is written in Python and NumPy and takes raw I/Q from rtl_sdr. It demodulates the FSK bursts, recovers the 38,400 baud serial stream, then Manchester decodes and checks the frames. Packets are written in the ramses_rf/evofw3 log format, and raw I/Q can be recorded and replayed. A local web dashboard shows zone temperatures, setpoints, heat demand, valve positions and OpenTherm values alongside a live packet log.

Hans tested it with an RTL-SDR Blog V4 and a dipole. Reception is passive, so no dedicated RAMSES gateway or firmware flashing is needed. The code is MIT licensed and available on GitHub, along with setup instructions and notes on the protocol and decoding.

The ramses-sdr Web Dashboard
The ramses-sdr Web Dashboard
Subscribe
Notify of
guest
0 Comments